Tuesday, April 19, 2011

Chapter 12,Quiz 6

Your Results:

The correct answer for each question is indicated by a This is the correct answer..

1
Incorrect
The easiest way to create fasteners on a bolt circle in AutoCAD LT® is to

A)create each fastener individually.

B)create one fastener and copy it to the other locations.

C)create one fastener and use a rectangular array to place the others.
This is the correct answer.
D)create one fastener and use a polar array to place the others.


2
Correct
When you create a rectangular array, the Array dialog box allows you to specify all of the following except

A)the amount of space between rows and columns.
This is the correct answer.
B)the size of each object in the array.

C)the number of rows.

D)the number of columns.


3
Incorrect
When you create a polar array, you can place the center point of the array by all of the following means except
This is the correct answer.
A)entering relative coordinates.

B)entering X and Y coordinates.

C)picking an arbitrary point anywhere in the drawing area.

D)using object snaps.


4
Incorrect
The total number of objects in an array consisting of six rows and four columns is

A)18.
This is the correct answer.
B)24.

C)36.

D)48.


5
Correct
The TOLERANCE command is used to apply

A)basic tolerances.

B)deviation tolerances.

C)limits tolerances.
This is the correct answer.
D)feature control frames and datum references.


6
Correct
When you pick the Sym box in the Geometric Tolerance dialog box, the

A)diameter symbol (Ø) appears.
This is the correct answer.
B)Symbol dialog box appears.

C)Datum dialog box appears.

D)radius symbol (R) appears.


7
Incorrect
The TOLERANCE command allows you to create multiple tolerances, up to a maximum of
This is the correct answer.
A)2.

B)3.

C)4.

D)5.


8
Incorrect
In the Material Condition dialog box, the blank box at the right end allows you to

A)specify a nonstandard material condition.

B)open a new dialog box with additional material condition options.
This is the correct answer.
C)remove an existing material condition from the feature control frame.

D)create a custom material condition symbol.


9
Incorrect
The Height box in the Geometric Tolerance dialog box

A)specifies the height of each tolerance in the feature control frame.

B)specifies the height of the entire feature control frame.

C)creates a primary datum references.
This is the correct answer.
D)creates a projected tolerance zone value.


10
Incorrect
The Projected Tolerance Zone box in the Geometric Tolerance dialog box
This is the correct answer.
A)inserts a projected tolerance zone symbol.

B)opens a dialog box allowing you to select a projected tolerance zone.

C)creates a projected tolerance zone value.

D)inserts a datum identifier.